Grading of logs is not so difficult as it appears although it does require great care to make sure that no hidden defects are overlooked. After acquiring experience, the grading of the log may be made while the volume is calculated. Even in the logs where the grading cannot be made immediately, it is often necessary to design the different cuttings. Usually measurements taken to determine whether the log will produce the minimum size required per cut, are sufficient to determine the grading. Grad the logs in standing trees by following the following rules and guides:

1. Grade all logs in tree, third best face.
2. Grade as logs or half logs (log = 16 feet; 1/2 log = 8 feet).
3. End defects of logs are not taken into consideration.
4. Grade all logs to the top cutoff point.
5. Do not grade the long-butt or total cull portion of a log, but do grade the remainder when equal to or more than 8 feet.
6. Do not grade logs that are obvious culls, but do tally them according to their position in the tree. Example: 1 for the first log, 2 for the second, etc.
7. Small bark distortion is a defect in logs whose diameter without bark (D.i.b) is less than 15“

EXCEPTIONS:

  Ash & Bass 12" DIB grade 1 butts
  Grade 2 10" DIB must be grade 1 surface quality
  Grade 2 11" DIB limited to two cuttings
  

Developed from FPL - D-1737